7,540
edits
Changes
→Tippek és trükkök
==Tippek és trükkök==
===Méretarány==
A viewporton belül mindig állítsuk be a méretarányt, ne az egérrel zummoljuk a modellt a helyére. Ha a viewporton belül a modelétreben vagyunk, vagyis kettőt kattintottunk a veiwporton belülre, akkor a bal alsó sarokban megjelenik a méretarány. Itt válasszuk ki a megfelelőt a listából:
:[[File:ClipCapIt-170101-201935.PNG]]
===Vizuális stílus===
A layouton a 3D-s képeket célszerű vagy egy renderelt képpel helyettesíteni, vagy mindig legyen Relalistic, az elölnézet legyen Conceptual, míg az oldalnézet, vagy ha fontos, hogy lássuk az kitakart elemeket, akkor meg 2D-Wireframe.
:[[File:ClipCapIt-170101-203217.PNG]]
===Dimension snaps to a zero measurement when dimensioning a 3D solid in paper space===
Issue:
When dimensioning a 3D solid in paper space, you snap to two different points, but the resulting dimension jumps to a zero distance value. The dimension may even be offset a distance from the object.
:[[File:ClipCapIt-170808-225832.PNG]]
'''Causes:'''
A combination of settings can contribute to this behavior:
* 3D Object Snaps are disabled
* Too many 3D Object Snaps are enabled. For example, Nearest may be interfering with trying to select an Endpoint.
* Too many Object Snaps are enabled. For example, Node may pick up on the origin of another dimension, when you are trying to choose an Endpoint.
'''Solution:'''
Test dimensioning your 3D solids with the following combination:
* Enable 3D Object Snaps by hitting the F4 key or typing 3DOSNAP
* Type 3DOSNAP and disable Nearest to face and Nearest to plane
* Type OSNAP and disable Node and Nearest while dimensioning
You may also have better success incorporating the following:
* If you would like to leave Node and Nearest OSNAP enabled, you can override your current OSNAP settings to only run with a single selection while the command is active
** Start a dimension command
** Click Shift+Right-Click
** Pick Endpoint
* Use the select object option for dimensions
** Start a dimension command
** Hit enter when prompted "Specify first extension line origin or <select object>"
** Pick a single segment
** The dimension will snap to the ends of that segment automatically
=Materials=