7,540
edits
Changes
→További vonal műveletek
Majd nyomjuk le a "c"-t, enter, kattintsunk a két határoló egyenes közepére,
:[[File:ClipCapIt-170612-001553.PNG]]
Ezután pedig határozzuk meg a végpontot.
===Forgatás egy vonalhoz képest===
Ha egy objektumot egy vonalhoz képest párhuzamosra akarunk elforgatni, akkor azt így kell:
# Start the ROTATE command and select the objects that you want to rotate.
# At the Specify base point: prompt, specify the base point of the object you want to reference to, not the base point of the object you want to rotate. This is point 1 in the above figure.
# At the Specify rotation angle or [Reference]: prompt, choose the Reference option.
# At the Specify the reference angle <0>: prompt, pick the point on the object that you want to rotate that corresponds to the base point you just specified. This is point 2 in the figure.
# At the Specify second point: prompt, pick the second point that, together with the previous point, specifies the angle of the object that you want to rotate. This is point 3 in the figure. Notice the rubber band line from your base point (point 1) connecting to your object as you move the cursor, as shown below:
:[[File:ClipCapIt-170704-221647.PNG]]
==Vegyes==